426 lb works out to 4x45 + 1x10 per side plus the bar — call it 425 lb in practice, since gyms rarely stock the odd change. 2 reps sits at the reliable end of the range these formulas were fitted on, so the 34 lb spread here is about as tight as the method gets. Your 405 lb set represents about 95% of the estimated max.
Why 2 reps gives a tight estimate
A double is the shortest set these seven equations accept, and it is where they agree most closely. Every one of them was regressed on sets of two to ten reps, so two sits at the near edge of the fitted band rather than outside it, and the 34 lb between 417 and 451 lb is about as narrow as this method ever gets. The uncertainty at two reps is not in the arithmetic, it is in the set: a double you could have taken one rep further looks identical on paper to one that genuinely stopped you.
Training loads from a 426 lb max
Programmes are written as percentages of the max, not as absolute weights. From 426 lb, rounded to the nearest 5 lb:
| Percentage | Load | Typical set |
|---|---|---|
| 95% | 405 lb | Heavy single |
| 90% | 385 lb | Doubles and triples |
| 85% | 360 lb | Sets of four to five |
| 80% | 340 lb | Sets of six |
| 75% | 320 lb | Sets of eight |
| 70% | 300 lb | Volume work, ten or more |
426 lb is 4x45 + 1x10 per side plus the bar, 425 lb loaded. At this load the 34 lb the formulas disagree by is bigger than a pair of 10s, which is a good argument for programming off the lower estimate — 417 lb — and letting the bar prove you wrong rather than the other way round. Warm-up jumps also get long here; work up in percentages rather than in fixed plate increments.
The formulas behind this answer, and their limitations
The table above the fold is Epley (1985), Brzycki (1993), Lombardi (1989), O'Conner (1989), Wathan (1994), Lander (1985) and Mayhew (1992), each applied to 405 lb for 2 reps; the headline figure is their median. All seven assume a set taken close to failure with clean technique. At 2 reps you are inside the band they were fitted on, so the largest error here is not the equation but judging how close your set really was to failure — three reps left in the tank reads exactly the same to them. They also under-rate strong, experienced lifters, who hold a higher percentage of max at any rep count than the regression average. The full account — the populations behind each equation, what a bounced rep does to it, and why we stop at ten reps — is set out on the methodology page. Warm up thoroughly and use safety bars or a spotter before going anywhere near 426 lb. This is a training estimate, not medical advice.