487 lb works out to 4x45 + 1x35 + 1x5 per side plus the bar — call it 485 lb in practice, since gyms rarely stock the odd change. At 10 reps the formulas are starting to drift apart — 36 lb between the lowest and highest here — which is the method telling you the estimate is getting soft. Treat the lower end as the safer number. Your 365 lb set represents about 75% of the estimated max.
Why 10 reps widens the answer
Ten reps is the last rep count with a page on this site, and it is the least reliable of them. All seven equations were fitted on sets of two to ten, so ten is the boundary itself; past it they diverge fast enough that we do not publish the pages at all. The 36 lb spread here — 7.4% — is the honest width of the answer. A ten-rep set measures endurance as much as strength, so if you want a number to programme from, repeat the test with four or five reps.
Training loads from a 487 lb max
Programmes are written as percentages of the max, not as absolute weights. From 487 lb, rounded to the nearest 5 lb:
| Percentage | Load | Typical set |
|---|---|---|
| 95% | 465 lb | Heavy single |
| 90% | 440 lb | Doubles and triples |
| 85% | 415 lb | Sets of four to five |
| 80% | 390 lb | Sets of six |
| 75% | 365 lb | Sets of eight |
| 70% | 340 lb | Volume work, ten or more |
487 lb is 4x45 + 1x35 + 1x5 per side plus the bar, 485 lb loaded. At this load the 36 lb the formulas disagree by is bigger than a pair of 10s, which is a good argument for programming off the lower estimate — 456 lb — and letting the bar prove you wrong rather than the other way round. Warm-up jumps also get long here; work up in percentages rather than in fixed plate increments.
The formulas behind this answer, and their limitations
The table above the fold is Epley (1985), Brzycki (1993), Lombardi (1989), O'Conner (1989), Wathan (1994), Lander (1985) and Mayhew (1992), each applied to 365 lb for 10 reps; the headline figure is their median. All seven assume a set taken close to failure with clean technique. At 10 reps you are at the top of the band these equations were fitted on, and beyond it they diverge fast, so 487 lb is a ceiling rather than a target. They also under-rate strong, experienced lifters, who hold a higher percentage of max at any rep count than the regression average. The full account — the populations behind each equation, what a bounced rep does to it, and why we stop at ten reps — is set out on the methodology page. Warm up thoroughly and use safety bars or a spotter before going anywhere near 487 lb. This is a training estimate, not medical advice.