353 lb works out to 3x45 + 2x10 per side plus the bar — call it 355 lb in practice, since gyms rarely stock the odd change. At 10 reps the formulas are starting to drift apart — 26 lb between the lowest and highest here — which is the method telling you the estimate is getting soft. Treat the lower end as the safer number. Your 265 lb set represents about 75% of the estimated max.
Why 10 reps widens the answer
Ten reps is the last rep count with a page on this site, and it is the least reliable of them. All seven equations were fitted on sets of two to ten, so ten is the boundary itself; past it they diverge fast enough that we do not publish the pages at all. The 26 lb spread here — 7.4% — is the honest width of the answer. A ten-rep set measures endurance as much as strength, so if you want a number to programme from, repeat the test with four or five reps.
Training loads from a 353 lb max
Programmes are written as percentages of the max, not as absolute weights. From 353 lb, rounded to the nearest 5 lb:
| Percentage | Load | Typical set |
|---|---|---|
| 95% | 335 lb | Heavy single |
| 90% | 320 lb | Doubles and triples |
| 85% | 300 lb | Sets of four to five |
| 80% | 280 lb | Sets of six |
| 75% | 265 lb | Sets of eight |
| 70% | 245 lb | Volume work, ten or more |
353 lb is 3x45 + 2x10 per side plus the bar — 355 lb loaded. Plate maths gets easier at this weight, because most of the jumps land on whole 10s and 25s. The bottom three rows of that table are worth rounding generously; the top two are where you want to be precise, since 5 lb at 95% of 353 lb is the difference between a single and a missed single.
The formulas behind this answer, and their limitations
The table above the fold is Epley (1985), Brzycki (1993), Lombardi (1989), O'Conner (1989), Wathan (1994), Lander (1985) and Mayhew (1992), each applied to 265 lb for 10 reps; the headline figure is their median. All seven assume a set taken close to failure with clean technique. At 10 reps you are at the top of the band these equations were fitted on, and beyond it they diverge fast, so 353 lb is a ceiling rather than a target. They also under-rate strong, experienced lifters, who hold a higher percentage of max at any rep count than the regression average. The full account — the populations behind each equation, what a bounced rep does to it, and why we stop at ten reps — is set out on the methodology page. Warm up thoroughly and use safety bars or a spotter before going anywhere near 353 lb. This is a training estimate, not medical advice.