195 lb works out to 1x45 + 1x25 + 1x5 per side plus the bar — call it 195 lb in practice, since gyms rarely stock the odd change. 2 reps sits at the reliable end of the range these formulas were fitted on, so the 16 lb spread here is about as tight as the method gets. Your 185 lb set represents about 95% of the estimated max.
Why 2 reps gives a tight estimate
A double is the shortest set these seven equations accept, and it is where they agree most closely. Every one of them was regressed on sets of two to ten reps, so two sits at the near edge of the fitted band rather than outside it, and the 16 lb between 190 and 206 lb is about as narrow as this method ever gets. The uncertainty at two reps is not in the arithmetic, it is in the set: a double you could have taken one rep further looks identical on paper to one that genuinely stopped you.
Training loads from a 195 lb max
Programmes are written as percentages of the max, not as absolute weights. From 195 lb, rounded to the nearest 5 lb:
| Percentage | Load | Typical set |
|---|---|---|
| 95% | 185 lb | Heavy single |
| 90% | 175 lb | Doubles and triples |
| 85% | 165 lb | Sets of four to five |
| 80% | 155 lb | Sets of six |
| 75% | 145 lb | Sets of eight |
| 70% | 135 lb | Volume work, ten or more |
195 lb loads as 1x45 + 1x25 + 1x5 per side plus the bar, or 195 lb on the bar. Round every figure in that table to the nearest 5 lb and stop there — the seven formulas disagree by 16 lb on this set, so chasing a two-pound difference is chasing noise. If your gym stocks 2.5 lb pairs, save them for the top two rows, where a small miss costs the most reps.
The formulas behind this answer, and their limitations
The table above the fold is Epley (1985), Brzycki (1993), Lombardi (1989), O'Conner (1989), Wathan (1994), Lander (1985) and Mayhew (1992), each applied to 185 lb for 2 reps; the headline figure is their median. All seven assume a set taken close to failure with clean technique. At 2 reps you are inside the band they were fitted on, so the largest error here is not the equation but judging how close your set really was to failure — three reps left in the tank reads exactly the same to them. They also under-rate strong, experienced lifters, who hold a higher percentage of max at any rep count than the regression average. The full account — the populations behind each equation, what a bounced rep does to it, and why we stop at ten reps — is set out on the methodology page. Warm up thoroughly and use safety bars or a spotter before going anywhere near 195 lb. This is a training estimate, not medical advice.